Reset Line (pin 52 on K64) is on pin 6 of J3 (2x8) - red wire on DediProg Split Cable PTA2 (EZP_DO) (pin 36 K64) is pin 12 j1 (2x8) and on pin 6 of SWD connector - GREEN Wire on DediProg Split Cable PTA1 (EZP_DI) (pin 35 k64) is on pin 8 of J1 (2x8) Black Wire on DediProg Split Cable PTA0 (EZP_CLK) (pin 34 k64) is on pin 2 of J2 (2x10) - Gray Wire on DediProg Split Cable K64 Pinout for PT0 – PT4 lines which are used for EzPort with Reset Line This cuts the clock signal from the OpenSDA circuit to PTA0 (SWD_CLK/EZP_CLK) of the K64 processor.ĭediProg Split Cable – Note Pin 3 – Orange is CS1 NOT MISO as shown in the picture The SWD connector is used a segger j-link to load and debug software.īefore connecting the programmer to the FRDM-K64, scratch out the trace jumper at J11 and install a two pin header. Most of the connection points required for EzPort on the FRDM-K64 board are exposed on the Serial Wire Debug (SWD) connector and on the Ardinuo headers. Unconnected to SWD connector but on pin 8 of J1 (2x8)on FRDM-K64 K64 pins vs SWD header on board vs SF600 DediProgammer pinout Table 2 from DediProg EzPort user manual for SF600 So the desktop software seems to be working –Ĭonnecting SF600 to K64 chip via SWD connector on my board. This is the Engineering software – there is also a production software Run SF6.0.4.39_Beta.msi software and follow prompts. Must tell operating system where inf file on CD or drive. Installation requires manually installing driver. This document contains set up info to Program and I hope Read Freescale MCUįollow directions provided in DediProg SF software user manual. I wanted to use EzPort to program boards in production which is why I selected teh DediProg SF600 Plus as it operates in a stand alone mode. I first tried to get the programmer working on my customer board that I've been programming / debugging with a Segger J-Link. Unfortunately, the directions are a bit vague and I’ve been unable to get the programmer to work. I’m following the directions provided by DediProg on setting up EzPort in the EzPortsupport.pdf document. I've purchased a SF600 Plus programmer and below are my notes on setting up the hardware and software. The purpose of this document is to determine if the SF600 Plus is compatible with EzPort feature of the MK64FN1M0VLL12 processor as claimed by the manufacturer. This document describes installing and testing of SF600 Plus DediProgrammer with Freescale K64 processor on FRDM K64 evaluation board. EzPort K64 Hardware Configuration Introduction
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |